Hello ! Welcome to Cheung Kong Machinery (HK) Limited !
4TECHNICAL

Points to note when using a slitter


01, check the product section of the number of joints with the number of their access is the same, hot melt adhesive coating machine if inconsistent immediately rewind check to prevent the internal connector mixed with the product.

02, according to the characteristics of semi-finished products, adjust the EPC device to ensure that the EPC photoelectric always in the tracking line, hand-pulled film end of the low-speed boot to make the film into the normal.

03, stop press the stop button, unloading hand is not allowed to touch the reel, so as not to be caught fingers.

04, slow start, observe the sub-cut film is in line with quality requirements, and then slowly start to cut, the machine is running, the hand is strictly prohibited into the machine, to avoid the back of the hand pressure.

05, the raw material bracket to open (close) to the appropriate width, the semi-finished products to be cut film roll loaded on the bracket, the material must leave the film when the hand section, not allowed to operate simultaneously to prevent hand Was caught by the cylinder.

06, the optical return to the central position, to ensure that the unwinding station slider to maintain the appropriate position in the middle of the guide stick.

07, to meet the specifications of the paper tube to wear on the receiving axis, the cut to meet the requirements of the product in accordance with the normal method of traction up and down the receiving axis of the paper tube, low-speed boot, find the paper tube on the receiving axis The location, marked in order to facilitate the next installation. When installing the paper tube, the hand must grasp the surface of the paper tube to prevent it from being bruised by the shaft.

08, all the slitting film according to operational requirements lead to the reel, the hot melt adhesive machine when the film is not allowed to wear the blade blade to defensive scratches.

09, according to the requirements of the MO to install the cutting knife holder to the appropriate location, fastening the knife, and then low-speed boot, the semi-finished products cut into the required specifications.

10, according to open the machine power, according to the requirements of the task list set up and retracted volume tension, the number of automatic stop counter and the thickness of the material set, open the photoelectric.